Brass stop
for Lenco idlerwheel hole with bore of 2.50 mm
When you
need to replace the wheel or lubricate its bore, it is necessary to remove and
then reinstall the original e-clip securing the wheel. This operation is made very
complex by the e-clip retainer which is hard to remove/reinstall on the shaft.
This issue cannot be solved by simply installing a wider e-clip as it would
easily move across the shaft causing the wheel to alter its position as well.
Therefore we
designed a small brass cylinder with a 2.5 mm bore was which through the use of
2 M2 grub screws can be correctly positioned in a matter of seconds, making the
whole task fast and easy.
The Brass
Cylinder kit includes both the needed M2 grub screws and a 0.9 hex key.
Please note
that it is essential that there be a 0.10 mm gap between the retainer and the wheel
so that it can spin freely.